HDPE waterproofing membrane products do a best wishes of maintaining your house dry and tidy, it’s among the good solutions for leaking houses because it’s affordable, it’s low maintenance, and it’s really very convenient.

It could be a leaking roof or perhaps a room leaking to another level of occupants, you can get damage to property and also neighborhoods. It is a ubiquitous architectural phenomenon, and in construction, leaking water may be the second biggest symptom in building quality. Now, many people have measures, waterproof coatings, waterproof membranes, as well as other products.

Precisely what are HDPE damp membranes?

HDPE damp membranes have been a self-adhesive waterproof material, that has you will of superior performance, hot temperature resistance, and sturdiness. Additionally, the self-adhesive film has a polymer adhesive layer.

HDPE damp membranes are constructed with high-quality high-density polyethylene resin, possibly at one time, ultraviolet absorbers, anti-aging agents, etc. may also be used.

Features of HDPE waterproof membrane

Durable

Long-lasting

Less maintenance

Supports construction on wet bases

An easy task to construct

Castable skeleton steel bar

It might form a super-strong bond with concrete, thus preventing the penetration of rain and moisture

Prepared to walk

Following the waterproof layer is done, it can be directly associated with the impact resistance of reinforced concrete without having a protective layer

Low requirements for that base layer, and is constructed on uneven and wet base surfaces

Not impacted by objective factors, thereby reducing construction costs

More flexible construction methods

Good waterproof performance

Widely application

Be it the top section of the ramp, the waterproofing with the tunnel, and the pool, it may be perfectly waterproofed. Simultaneously, HDPE damp membranes can be used high-requirement waterproof projects and some gas leakage prevention.

Installation tips

Keep the base layer clean first. When the sharp part of the protrusion is located, it will be processed to get flat. In case there are more water stains, keep the base layer moist.

Unroll the membrane. When laying the video on the base layer, you need to pay attention to the particles with the film facing up, along with the edges present in adjacent films should be aligned to prevent overlapping.

The way to determine the thickness with the film meets what’s needed?

This method is extremely brief, have a needle and randomly select 3 points per 100 square meters for the membrane for penetration experiments. Dimensional measurements were created for that thickness in the 3 needle punches respectively, lastly, the average value was taken for their heights. If the average thickness is bigger than 1.5mm, it meets certain requirements.

For details about màng hdpe see this popular resource: click here